To make duct tape wallet, you will need following things: 1. Duct tape; 2. Scissors; 3. A ruler; 4. A utility knife; 5. A cutting board, or thick board to cut on; 6. A library card or credit card for sizing.
Related articles about How to make duct tape wallet
Build the main body of the wallet.
Initially, remove 4 pieces of conduit tape that are 9 creeps long. Layer them sticky side up to 1/2 inch of cover between each piece. Then, remove 4 more strips the same length. Stick these to the sheet you simply made, yet begin around 1/2 inch down from the top. That way, you will stun the covering segments and not make the pipe tape too thick to fold. I utilized a print for the outside of the wallet and a strong for within to spare a little money. Fold the edges over. At that point, utilize your utility blade to trim both closures of the sheet. Your completed width ought to be 8.5 inches, And it ought to be around 6 inches tall.
Make one large credit card pocket
Detach two 5 inch strips and layer them. At that point, stick two more 5 inch strips to the back and overlap over the edges, taking after the same technique as the primary body of the wallet. Trim the edges with the utility blade and ruler so this pocket measures 4 creeps wide.
Make two smaller credit card pockets
Remove two 9 inch portions of conduit tape, and stick them consecutive. Cut this piece into two pieces that are every 4 inches wide. Tear a segment of channel tape down the middle the long way to make trim for the highest point of these pockets. Fold the trim over the highest point of the pockets and trim off the additional.
Assemble the pockets
Lay the three pockets on top of one another, with the biggest pocket on the base. The center pocket won’t go the distance down to the base, and that is alright. Utilize a segment of tape torn into equal parts the long way to append them.
Utilize your charge card or library card to ensure that you have enough room in the pockets! You will likely need a greater amount of the tape hanging over onto the other side – it won’t be isolated equitably.
Assemble the wallet
Lay out your primary fabric to the side UP that you need to be on the OUTSIDE of the wallet. Attach the Visa pockets to the upper right with a 9 inch portion of channel tape torn into equal parts lengthwise. Then, fold the wallet down the middle and secure the ends with pieces of tape that have been torn fifty-fifty the long way. Trim off the extra. Add a last portion of tape over the base of the wallet, and you’re finished!
